Welcome to Tribbeck.com

Martian - day 2

The previous day, I'd printed the entire foot out, but the tolerances were too tight and during printing, the hinges fused together:

So I adjusted the toes a little bit.

Click to download

And I printed out the single toe - and it's able to bend a bit:

Click to download Click to download

It's not designed to bend too much the other way - a lot like the human foot.

And a little bit more in order to increase the size of the pins so they weren't quite as wobbly, and also add a little more detail:

Click to download

This was printed out again, and it was a bit tighter.

Click to download Click to download

And then I made two more copies (as before), with 120° and 240° rotations:

Click to download Click to download

The hole in the middle is for the ankle hinge mechanism, which I'll make tomorrow

« Previous day | Next day »

Updated: 2015-03-19 20:07:59 | Comments: 0 | Show comments | Add comment
© Copyright 1997-2019
Tribbeck.com / Jason Tribbeck
All trademarks are the property of their respective owners.